![]() ![]() Check that there are plug outlets (in the wall or floor) for any table or floor lamps you have planned.Check that the switch panel design, or individual switch layout if grouped in one location are properly specified. ![]() Check that dimmer switches are specified where you want them.Check that the switches are in a sensible place – both the location in the room and the height on the wall.Is the 3 way switch for the central fixture specified correctly. For example you might want a switch for the central fixture at each end of the room, and a separate switch for the circuit that has the lamp outlets. Check that all the correct fixtures are on the correct circuits with the correct switches.Check that the correct type of light fixture is specified.Pilot light switch - A switch with a little light that indicates that the circuit is on.Ĭhecklist for lighting symbols on blueprints ![]() This is really useful for the top and bottom of the stairs.įour way switch - Used in between two three way switches to controlling a light from three locations. So no prizes for figuring out that they need to be used in pairs. Three way switch - It's not very intuitive but a three way switch allows a light to be turned on and off from two locations. Other atypical mounting positions may be designated by compass points or numbering in a clockwise manner. Pipe grid positions should be designated by numbers on one axis of the grid and by letters on the other axis. It allows a light to be turned on and off from a single location.ĭouble pole switch -This is the same as the single pole switch in that it turns a light on and off from a single location but it has two 'hot' wires so it can handle 220v. 2.3.3 Designation and numbering of mounting positions in non-proscenium venues. Single pole switch - This is the most common type of switch. Let's just get some of those switch names explained. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |